1·Parting line locks are required on all molds.
琐模块所有的模具都需要。
2·Too many undercuts, we suggest to change the part structure along the parting line.
太多倒扣，我们建议沿些此分型线更改产品设计。
3·The injection mould parting line and its sequence as sizing space split were described.
主要阐述了注射模的分型面以及它的顺序、定距分型。
4·The parting line or the parting surface is line or surface that separates the cope and drag.
分型线或分型面是分离上下型箱的线或面。
5·The part may stick on the angle lifter, so we need to consider the parting line for this area.
产品可能粘斜顶，所以我们需要考虑粘斜顶的部分如何分型。
6·When you design this type of plastics mold, parting line must be designed according the Max silhouette curves.
当您设计这种类型的塑料模具，型线的设计必须根据马克斯轮廓曲线。
7·In this paper, a new approach to automatically searching the parting line in injection mold design is introduced.
提出了一种自动搜索模具分型线的方法。
8·Coining is usually done on surfaces parallel to the parting line, and little metal flow is involved in the operation.
铸币通常是做表面平行的线，与小金属流动是参与行动的。
9·If the parting line cannot be on a single plane, then it is good practice to use symmetry of the design to minimize the side thrust forces.
如果分模面不能在单一平面，利用设计的对称性来减小侧向推力不失为一种好方法。
10·Heaping on the clamp force, makes the mold harder to "breathe" or vent, and over time, can permanently hob closed the vents on the parting line.
多余的锁模力，可能让模具无法“呼吸”或排气，周期超时等，对模具分模线的挤压。